A very simple design is given here. Mark out the dimensions on a sheet
of paper and lay the design on a sheet of brass. Cut the brass out to
fit the design. Using the mallet, drive up the rounding part on the
anvil stake to match the rounding part on the tray.
[Illustration]
_Handle of scraper:_ Place the handle part on a hard wood block and
with the small end of the raising hammer drive down on the handle,
embossing it from the outside toward the front. Give it a half hollow
shape. If the edge of the handle is smoothed off with a file and made
rounding, it makes a good handle for the scraper. Flatten the scraping
edge so that it lies flat on the table and picks up all the crumbs on
its way to the tray. Polish and finish as you did the tray.
[Illustration]