Remove old one, pick out old stitches in coat collar (the old stitches
in velvet do not matter), place coat in a convenient manner on the
press-jack and press collar and lapels into shape.
Cut new velvet collar one-eighth inch larger on each side than the
pattern, or larger if necessary, and steam over an iron as explained.
Stretch the edges a trifle on each side of velvet, being careful not to
leave finger or thumb marks, and when cool, baste on coat, (silk thread
should be used when basting velvet) in collar crease through velvet to
hold in place.
Run another basting below crease and in the stand of collar, and another
row of basting on leaf of collar close to the crease. Run another
basting near the outside edge of collar leaf, and form a cushion at each
end to allow ample room for ends to curl under (instead of up). See that
the velvet is not basted on too tight or too short.
Now turn velvet in over old seam or stitches on the inside of coat
collar, from end to end; and baste velvet over edge and all around leaf.
Now cut velvet off even along the leaf, then fell inside of velvet to
coat neck with silk to match; and herringbone velvet to leaf all around
from end to end. Make a loop or hanger out of a straight piece of lining
one-half inch wide, and turn all edges in and fold again and fell
together; now sew to the coat as before, turning both edges of loop in,
and tacking same through stand of collar. Remove all basting by cutting
each stitch and pulling out from the right side, and with the nap of the
velvet.