CHAPTER II

EARLY TRAMROADS AND RAILWAYS

It has sometimes been remarked, by unfriendly critics, that tramways

are an apology for bad roads. That is to say, if road surfaces were

perfect, there would be no need to lay rails in order to allow vehicles

to run easily.

Although this view of the case may be no better than a quarter-truth,

it is justified to the extent that tramways were, as a matter of fact,

the outcome of an attempt to escape from bad road surfaces. In the

early days of mining, coals were taken by horsedrawn wagons from the

pits to the harbours. The passage and re-passage of heavy vehicles on

the same roadway led to the formation of deep ruts; and the first step

towards both the tramway and the railway was taken when logs of wood or

'trams' were laid in the ruts to facilitate transport.

The next step was to make the upper surface of the log round and the

rims of the wheels hollow, so that they fitted over the rails and kept

the wagons on the track. Owing to the upper part of the rails wearing

away quickly, thin plates of iron were in some cases nailed to them.

This improvement led to the adoption of a cast-iron rail, fastened to

wooden sleepers.

The earliest cast-iron railway was laid down before the middle of the

eighteenth century, about one hundred years after the first wooden

'tram-ways.' Half a century later we find the first rail-and-wheel

combination as we know it on modern tramways and railways, where the

wheel carries an inner flange and runs upon the head of a narrow metal

rail. This is the form which experience has proved to be best adapted

for safety, speed, and economy in power. The improvements made since

the beginning of the nineteenth century have been in matters of detail.

Many miles of colliery tramroads were in existence when--at the

beginning of the nineteenth century--the idea of using the steam engine

in place of the horse was taken up by engineers. They were concerned

at first solely with the carriage of coal; the idea of conveying

passengers arose at a later date, after the steam automobile had

been tried and abandoned for the time being. George Stephenson, for

instance, ran his first locomotives on colliery tramroads; and the

first railway--between Stockton and Darlington--was used for passengers

merely as an afterthought. It was, in fact, designed to be a tramroad

for the use of the public in general transport by horse traction.

The most curious feature of this stage in the evolution of locomotion

was that, although Stephenson's locomotives had been at work for

several years and although several schemes of iron roads had been

projected, very few people had any conception of the development

awaiting the locomotive and iron road in combination. They did not even

appreciate the proved fact that the locomotive was a more efficient

means of transport than the horse. An immense amount of pioneering work

had to be done before the impression of a new era could be borne in

upon the public mind. These were the days when the _Quarterly Review_

backed 'old Father Thames against the Woolwich Railway for any sum' and

when a witness before a Parliamentary Committee (on the Liverpool and

Manchester Railway Bill, in 1825) thought himself safe in suggesting

that a steam locomotive could not start against a gale of wind.

When these prejudices were overcome, many years had to pass before

the objections of landowners and citizens were worn down. Railway

engineers spent most of their time in a form of diplomatic warfare with

opponents to their schemes; huge sums--part of which still lingers in

the capital accounts of railway companies--were spent in Parliamentary

proceedings over Railway Bills. This barren process had to be repeated

when electric traction made its appearance; but happily the electrical

fight was not upon quite so extensive a scale, nor was the period

of preparation followed by anything comparable to the Railway Mania

of 1845, when the public made up for its early contempt of railway

enterprise by tumbling over itself to get shares in some of the most

crazy schemes which were ever put into shape by unscrupulous company

promoters.

The early history of the steam railway is interesting in connection

with electrical locomotion for two reasons. It shows that the railroad

proper evolved out of the tramroad or 'light railway,' as it would

now be called--a type of line which is specially suited to electrical

operation. It also includes a controversy between three modes of

traction; and this controversy forms a very good introduction to

a discussion of the reasons why electricity is so economical in

locomotion.

These three modes were (1) stationary engines: (2) locomotives: (3) the

device known as the 'atmospheric railway.'

In both the first and third, engine houses were placed close to the

line at convenient intervals. In the first, each steam engine operated

an endless rope to which the train of carriages was attached. The

system is still in use for colliery working and is also employed (in

an improved form, of course) for funicular railways. George Stephenson

himself employed it to assist locomotives up heavy gradients. In the

atmospheric railway the stationary engines were used to exhaust the

air from a length of cast-iron piping laid close to the railway. The

principle is the same as that of the 'pneumatic tube' which the Post

Office uses for sending papers over short distances. The papers are

placed in a cylinder which fits the interior of the tube; and when the

air is exhausted from the tube in front of the cylinder, the pressure

of the air behind it drives the cylinder forward.

Nowadays it is difficult to realise that such a system was seriously

proposed for railway work and actually adopted by an engineer of such

eminence as Brunel. But in point of fact it was recommended by two

Board of Trade experts in 1842 and by a Select Committee appointed in

1845 to consider several Bills for atmospheric railways. It was tried

at Dalkey and Croydon, and it was installed under Brunel's supervision

on a six-mile line in Devon. The carrier in the tube was connected

to the train through a longitudinal slit at the top of the tube. The

slit was closed by a leather flap, except when momentarily lifted by

the passage of the train. A great deal of ingenuity was exhausted in

attempting to make this 'longitudinal valve' efficient, but it was

found that heat, moisture, and frost made the leather deteriorate so

rapidly as to render it hopelessly ineffective in a short time. After a

series of misfortunes the atmospheric railway became a mere curiosity

in the history of invention.

Stephenson was right in regarding the atmospheric railway as 'only

the fixed engine and ropes over again, in another form.' He was also

right in his belief that the steam locomotive was more economical

than either of its rivals. But the stationary engine idea had the

germ of an even sounder principle than that of the locomotive. Both

in electric tramways and electric railways the power is obtained from

stationary engines. The main difference between the electric system

and the old rope and atmospheric systems lies in the superior economy

with which the power is conveyed electrically to the trains. There are

other important differences; but the essential point is that both rope

traction and pneumatic propulsion wasted so much power between the

engine and the train that their other advantages were annulled, and it

was found cheaper to put the engine on wheels and make it drag itself

as well as the train.

Brunel's reasons for his faith in the atmospheric railway are well

worth quoting for the light they throw indirectly upon the advantages

of electric traction. He argued that stationary power, if freed from

incumbrances such as the friction and dead weight of a rope, was

superior to locomotive power, on the following grounds:

(_a_) A given amount of power may be supplied by a stationary engine at

a less cost than if supplied by a locomotive.

(_b_) The dead weight of a locomotive forms a large proportion of the

whole travelling load, and thus inherently involves a proportionate

waste of power--a waste which is enhanced by the steepness of the

gradients and the speed of the trains.

Experience has proved the soundness of these principles. There has

been a steady improvement in the power and efficiency of locomotives,

but progress has reached a point at which further increases in speed

and accelerating power (a very important matter) are not attainable

without a prohibitive increase in the consumption of coal and a costly

strengthening of the railway track to stand the strain of heavier

engines pounding along at very high speeds. Electric traction, which is

a reversion in part to the stationary engine system, offers a means of

escape from the limitations of the locomotive.

There is still some doubt in the minds of railway engineers whether

electric traction is really superior to the steam locomotive on the

main railway lines, where distances are great and train loads heavy.

But the superiority is admitted on suburban lines and also on tramways,

where electricity has almost completely supplanted both horse and steam

traction. If Brunel had foreseen how economical electricity would be in

the transmission of power between engine and train, he would have felt

still more confident in his defence of the stationary engine.

Electricity in Locomotion An Account of Its Mechanism, Its Achievements, and Its Prospects · 第 2 / 16 章