What makes ice slippery?
How does a brake stop a car?
Why do things wear out?
It would not be such a calamity if we were to turn off friction from
the world. Still, I doubt whether we should want to leave it off much
longer than was necessary for us to see what would happen. Suppose we
imagine the world with all friction removed:
A man on a bicycle can coast forever along level ground. Ships at
sea can shut off steam and coast clear across the ocean. No machinery
needs oiling. The clothes on your body feel smoother and softer than
the finest silk. Perpetual motion is an established fact instead of an
absolute impossibility; everything that is not going against gravity
will keep right on moving forever or until it bumps into something
else.
_But_, if there is no friction and you want to stop, you cannot.
Suppose you are in an automobile when all friction stops. You speed
along helplessly in the direction you are going. You cannot steer the
machine--your hands would slip right around on the steering wheel, and
even if you turn it by grasping the spoke, your machine still skids
straight forward. If you start to go up a hill, you slow down, stop,
and then before you can get out of the machine you start backward
down the hill again and keep on going backward until you smash into
something.
A person on foot does not fare much better. If he is walking at the
time friction ceases, the ground is suddenly so slippery that he falls
down and slides along on his back or stomach in the same direction he
was walking, until he bumps into something big or starts to slip up
a slope. If he reaches a slope, he, like the automobile, stops an
instant a little way up, then starts sliding helplessly backward.
Another man is standing still when the friction is turned off. He
cannot get anywhere. As soon as he starts to walk forward, his feet
slip out from under him and he falls on his face. He lies in the same
spot no matter how he wriggles and squirms. If he tries to push with
his hands, they slip over the rough ground more easily than they now
slip through air. He cannot push sideways enough even to turn over. If
there happens to be a rope within reach and one end is tied to a tree,
he might try to take hold of the rope to pull himself along. But no
matter how tightly he squeezes, the rope slips right through his hands
when he starts to pull. If, however, there is a loop in the rope, he
can slip his hand through the loop and try to pull. But the knots with
which the rope is tied immediately come untied and he is as helpless
as ever.
Even if he takes hold of a board fence he is no more successful.
The nails in the board slip out of their holes and he is left with a
perfectly slippery and useless board on the ground beside him for a
companion. As it grows cold toward evening he may take some matches
out of his pocket and try to start a fire. Aside from the difficulty
of his being unable to hold them except by the most careful balancing
or by shutting them up within his slippery hands, he is entirely
incapable of lighting them; they slip over the cement beneath him or
over the sole of his shoe without the least rubbing.
In the real world, however, it is fortunately as impossible to get
away from friction as it is to get away from the other laws we have
tried to imagine as being turned off. There is always some friction,
or rubbing, whenever anything moves. A bird rubs against the air,
the point of a spinning top rubs against the sidewalk on which it is
spinning. Your shoes rub against the ground as you walk and so make
it possible for you to push yourself forward. The drive wheels of
machinery rub against the belts and pull them along. There is friction
between the wheels of a car and the track they are pushing against, or
the wheels would whirl around and around uselessly.
[Illustration: FIG. 24. Hockey is a fast game because there is little
friction between the skates and the ice.]
But we can increase or decrease friction a great deal. If we make
things rough, there is more friction between them than if they are
smooth. If we press things tightly together, there is more friction
than if they touch lightly. A nail in a loose hole comes out easily,
but in a tight hole it sticks; the pressure has increased the
friction. A motorman in starting a trolley car sometimes finds the
track so smooth that the wheels whirl around without pushing the car
forward; he pours some sand on the track to make it rougher, and
the car starts. When you put on new shoes, they are so smooth on the
bottom that they slip over the ground because of the lack of friction.
If you scratch the soles, they are rougher and you no longer slip.
If you try to pull a stake out of the ground, you have to squeeze it
harder than the ground does or it will slip out of your hands
instead of slipping out of the ground. When you apply a brake to an
automobile, the brake must press tightly against the axle or wheel to
cause enough friction to stop the automobile.
There are always two results of friction: heat and wear. Sometimes
these effects of friction are helpful to us, and sometimes they are
quite the opposite. The heat from friction is helpful when it makes
it possible for us to light a fire, but it is far from helpful when it
causes a hot box because of an ungreased wheel on a train or wagon, or
burns your hands when you slide down a rope. The wear from friction is
helpful when it makes it possible to sandpaper a table, scour a pan,
scrub a floor, or erase a pencil mark; but we don't like it when
it wears out automobile tires, all the parts of machinery, and our
clothes.
EXPERIMENT 17. Hold a nail against a grindstone while you turn
the stone. Notice both the wear and heat. Let the nail rest
lightly on the stone part of the time and press hard part of
the time. Which way does the nail get hotter? Which way does
it wear off more quickly? Run it over a pane of glass and see
if it gets as hot as it does on the grindstone; if it wears
down as quickly.
WHY WE OIL MACHINERY. We can decrease friction by keeping objects
from pressing tightly against each other, and by making their surfaces
smooth. The most common way of making surfaces smooth is by oiling
or greasing them. A film of oil or grease makes things so smooth and
slippery that there is very little friction. That is why all kinds of
machinery will run so smoothly if they are kept oiled. And since the
oil decreases friction, it decreases the wear caused by friction.
So well-oiled machines last much longer than machines that are not
sufficiently oiled.
[Illustration: FIG. 25. The friction of the stone heats the nail and
wears it away.]
WHY BALL BEARINGS ARE USED. There is much less friction when a round
object rolls over a surface than when two surfaces slide over one
another, unless the sliding surfaces are very smooth; think how much
easier it is to pull a wagon forward than it would be to take hold
of the wheels and pull the wagon sidewise. So when you want the least
possible friction in a machine you use ball bearings. The bearings
are located in the hub of a wheel. Then, instead of the axle rubbing
against the hub, the bearings roll inside of the hub. This causes very
little friction; and the friction is made still less by keeping the
bearings oiled.
_APPLICATION 14._ Suppose you were making a bicycle,--in
which of the following places would you want to increase the
friction, and in which would you want to decrease it? Handle
grips, axles, pedals, tires, pedal cranks, the sockets in
which the handle bar turns, the nuts that hold the parts
together.
_APPLICATION 15._ A small boy decided to surprise his mother
by oiling her sewing-machine. He put oil in the following
places:
On the treadle, on the large wheel over which the belt runs,
on the axle of the same wheel, on the groove in the little
wheel up above where the belt runs, on the joint where the
needle runs up and down, on the little rough place under the
needle that pushes the cloth forward. Which of these did he do
well to oil and which should he have let alone?
INFERENCE EXERCISE
Explain the following:
61. Rivers flow north as well as south, although we usually
speak of north as "up north."
62. Tartar and bits of food stick to your teeth.
63. Brushing your teeth with tooth powder cleans them.
64. When a chair has gliders (smooth metal caps) on its feet,
it slides easily across the floor.
65. When you wet your finger, you can turn a page more easily.
66. A lamp wick draws oil up from the lower part of a lamp to
the burner.
67. The sidewalks on steep hills are made of rough cement.
68. Certain fish can rise in the water by expanding their air
bladders, although this does not make them weigh any less.
69. When your hands are cold, you rub them together to warm
them.
70. It is dangerous to stand up in a rowboat or canoe.
CHAPTER THREE
CONSERVATION OF ENERGY