Using both sides, this mould casts five of the most used connectors for
all batteries, using Standard Jars, 7-9-11-13-15 Plate four end
connectors (two Dodge Tapers and two Standard Tapers, Negative and
Positive), one end connector, ⅜-inch wire leed used on 12-volt Maxwell
and other cars using wire leed. One small wire leed to connect with end
post on storage battery requiring direct connection. Post support rings,
which fit the two sizes standard rubber covers; also fit perfectly all
posts cast with our post mould. Two handy washers that sometimes are
badly needed when installing a new or rent battery.
[Illustration: Figure 8A[1]]
Extra taper plugs can be furnished, also extra bushings for different
size cable. Standard equipment as furnished includes four taper plugs,
one large and one small cable bushing.
The top connectors most frequently replaced are the taper end
connections and end connections with wire cable leads. For battery men
desiring these parts, but not the large combination link mould, the
AMBU-Washburn terminal mould, Figure 9, has been designed. It has the
same general good features of the larger mould, and casts four end
connectors, one wire cable leed and two washers.
[Illustration: Figure 9[1]]