INSTRUMENT PANEL
Paragraph
Panel cover 119
Indicator lights 120
Speedometer head 121
=119. PANEL COVER= (fig. 80).
=a. Remove.= Remove speedometer light switch knob and remove screw.
Remove hexagon‐head screw on front of cover. Remove two screws from
side of cover. Remove two screws and washers which fasten plate to
right side of cover. Lift cover off panel.
[Illustration: RA PD 315731
_Figure 80—Panel Cover Removed_]
=b. Install.= Position cover on panel. Install two side mounting
screws and washers and install hexagon‐head screw, plain washer, and
lock washer in front end of cover. Attach cover side plate, installing
two screws and washers. Install speedometer light switch knob and screw.
120. INDICATOR LIGHTS.
=a.= Three 2-c.p. single‐contact lamps are located on instrument panel.
One for oil pressure (red) indicator light: one for generator‐charge
(green) indicator light, and one for speedometer illumination.
=b. Remove and/or Install.= Remove and/or install panel cover (par.
119).
=c. Test Generator‐Charge (Green) Indicator Lamp.= Disconnect black
wire from relay terminal (top terminal at front end of relay) and
ground on relay base. Turn ignition and light switch on. Lamp should
light. If it does not light, check wire for condition and/or replace
lamp after removing panel cover (par. 119).
=d. Test Oil Pressure (Red) Indicator Lamp.= Disconnect wire from oil
pressure switch. Ground the wire on engine. Turn ignition and light
switch on. Lamp should light. If it does not light, check wire for
condition and/or replace lamp after removing panel cover (par. 119). If
lamp and wiring are satisfactory, replace oil pressure switch.
121. SPEEDOMETER HEAD.
=a. Remove.= Remove instrument panel cover (par. 119). Loosen the
two tank front mounting bolts and remove rear mounting bolt to free
speedometer cable clamp. Disconnect speedometer cable at drive unit.
Free cable from clip located below tool box. Remove two screws which
mount head to frame. Pull head upward, working cable forward under
tank, until head and cable connection nut is clear of frame. Unscrew
cable nut. NOTE: _Cable may be secured to frame tube, between tanks,
with friction tape. If so, cut tape._
=b. Install.= Attach speedometer head to cable end and tighten nut.
Pass cable down into frame hole, pulling on rear of cable at same time.
Mount speedometer head to frame with two screws and lock washers.
Install panel cover (par. 119). Secure cable clamp under head of tank
rear mounting bolt. Secure cable in clip, located under tool box.
Attach end of cable to drive unit. Tighten the two tank front mounting
bolts.