_a._ This can best be tried by adding one or, in some cases, two more
streams than the pump is rated to deliver by attaching the extra lines
of hose to some hydrant near, and then speed up the pump gradually,
to see how fast it may be run before violent pounding or slamming of
valves begins.
Sometimes the increased delivery can be drawn off through an open
hydrant-butt meanwhile holding sufficient back pressure to show 100
pounds on the water gauge by partly closing the discharge valve.
The engine driver should stand with his hand on or near the throttle
when thus speeding the pump.
It is all right to run a fire-pump up to the utmost speed possible
before water hammer begins, and very often a pump, while new and if
favorably set up, can deliver 25 to 50 per cent. more than rated
capacity; nevertheless, although expert treatment can force 1,000
gallons from a 16 × 9 × 12 pump we can rate it as only a 750-gallon
pump. _There must be some margin to allow for wear and for the
possible absence of the expert at time of fire._
THE MAIN POINTS OF DIFFERENCE BETWEEN THE “NATIONAL STANDARD” AND THE
“TRADE PUMP” ARE:
Brass Plungers instead of cast-iron plungers.
Wrought iron side levers instead of cast iron.
Bronze piston rods and valve rods instead of iron or steel.
Pump has brass-lined stuffing boxes instead of cast iron.
Rock shafts are brass bushed.
Area of water valves is 25 to 50 per cent. greater.
Steam and exhaust passages 20 to 50 per cent. greater.
Suction pipe connections two to four inches greater diameter.
Cushion valves better arranged.
Air chamber is made much larger.
Shells and bolting are warranted especially strong.
The following necessary fittings are included in the price, and
regularly furnished as a part of this pump, viz.:
A capacity plate.
A stroke gauge.
A vacuum chamber.
Two best quality pressure gauges.
A water relief valve of large capacity.
A cast iron relief valve discharge cone.
A set of brass priming pipes and special priming valves.
From two to six hose valves.
A sight feed cylinder lubricator connected above throttle.
A one-pint hand oil pump connected below throttle.
Information regarding tests made under these specifications can be
obtained by addressing Underwriters’ Laboratories, Chicago, Ill.